External Monitor Connection - Sharp XG-E690UB Operation Manual

4
INPUT
COMPUTER
RGB
Direct
connection
External IBM-PC
monitor
5
10
15
Computer Input
Analog
1. Video input (red)
2. Video input
(green)
3. Video input
(blue)
4. Reserve input 1
5. Composite sync
(Mac only)
6. Earth (red)
7. Earth (green)
E-11
FILTER
OUTPUT
OFF ON
Optional third source
VGA/Mac adaptor cable
U.S.A. ONLY
or
External Macintosh
monitor
1
6
11
8. Earth (blue)
9. GND
10. GND
11. GND
12. Reserve input 2
13. Horizontal sync
signal
14. Vertical sync
signal
15. Reserve input 3
3. Connecting to other compatible
computers
When connecting the projector to a compatible computer
other than an IBM-PC (VGA/SVGA) or Macintosh series, a
separate cable is needed. Please contact your dealer for
ordering information.
Notes:
• Connection to computers other than the recommended
types may result in damage to the projector, the computer,
or both.
• Connect the audio from the computer to the COMPUTER
AUDIO INPUT terminal.

4. External monitor connection

Connect your computer monitor to the projector's COMPUTER
RGB OUTPUT terminal to view images simultaneously on the
external monitor and the projection screen.
Caution (Apple Macintosh)
Do not connect the COMPUTER RGB OUTPUT to any
monitor except the following:
Apple Color RGB Monitor: 13 /14 (640 x 480) or 16 /17
(832 x 624)
The output signal from the projector to the monitor should
be the same as the input signal from the computer to the
projector.
Example: Input 13"/14" (640 x 480)
Input 16"/17" (832 x 624)
Note:
• When using the projector with an external IBM-PC monitor,
connect the monitor using the supplied cable. When using
the projector with a Macintosh monitor, an optional adaptor
cable is required. Before using any other type of monitor,
carefully check the monitor's interface specifications and
make sure that they match the specifications of the
projector's interface.
The external monitor output will only display an analog
computer input signal. It will not display a digital or video
input signal. To split the composite video signal, use a
video distribution amplifier. This is available from your local
dealer.
The computer RGB output will only loop through the same
signal connected to the computer RGB input.
(VGA IN VGA OUT, Mac IN
Analog RGB Signal Input and Output
Connector
This unit uses a 15-pin mini D-sub female connector. Pin
assignment is as shown on the left.
Output (640 x 480)
Output (832 x 624)
Mac OUT)