Table of Contents
Advertisement
Mac
The number of displayed segments
(0~60) increases or decreases as
the volume is raised or lowered.
3 8
V O L U M E
ON/OFF
POWER
LAMP
TEMP.
8. Press INPUT CHECK.
When the INPUT CHECK button on the remote control is
pressed, the current input mode is displayed for about 4
seconds.
Note:
The INPUT CHECK button will not function if the INPUT
DISPLAY is turned off, as described on page 31.
9. Adjust the volume.
Press the VOLUME UP-DOWN buttons on the projector
or on the remote control to adjust the volume.
MUTE
Press the MUTE button to temporarily turn off the
sound.
Press the MUTE button once again to turn the sound
back on.
10. To turn off the power from the projector
or remote control
The power can be temporarily turned off by pressing the
POWER ON/OFF button on either the projector or remote
control.
The POWER indicator will turn red and the cooling fan
will run for 90 seconds, then the power will turn off,
and the projector will return to STANDBY mode.
The power can be turned on again either from the
projector or remote control. When the power is turned
on, the POWER indicator and LAMP REPLACEMENT
indicator light green.
Note:
When the MAIN POWER is off on the projector set, the power
cannot be turned on from the remote control.
E-24
Advertisement
Table of Contents
