Setting Up The Projector - Sharp XG-E1200U Operation Manual

Setting Up the Projector

Using the Focus, Zoom and Lens Shift
Lens Shift, Zoom, Focus and Reversed/Inverted Image mode functions broaden your options
for projector placement.
See pages 10, 12 and 13 for details on projector setup.
SIDE VIEW
2
3
SHIFT
S H I F T
S H I F T
E-9
Lens Shift
ON/OFF
POWER
POWER
indicator
LAMP
TEMP.
FOCUS
F O C U S
ZOOM
Z O O M
Zoom
Ceiling setting
IN E-Z LN ADJ. EN MN
SELECT VOLUME MUTE E-ZOOM LENS ENTER MENU
INPUT
Table setting
Zoom
1. Turn on the MAIN POWER.
Turn on the MAIN POWER switch on the side of the
projector.
2. Turn on the POWER.
Press the POWER ON/OFF button on the projector or the
POWER ON button on the remote control to turn on the
power.
3. Press the LENS button.
When using the remote control to adjust the picture,
move the MOUSE/ADJUSTMENT sliding switch to the
ADJUSTMENT position. When the LENS button on the
remote control or on the projector is pressed, the LENS
adjustment mode is indicated for about 8 seconds.
If the LENS button is pressed while the mode is indi-
cated on the screen, the picture adjustment mode
changes as shown on the left.
You can adjust the picture as shown on the left by
pressing the ADJUSTMENT ( ) or ( ) buttons while in
ADJUST mode.
Note:
• Do not attempt to adjust the lens by hand as it may damage
the lens mechanism.
Adjust the focus until the picture on the screen is sharp.
The focus pattern appears on the screen.
The picture can be adjusted to the desired size within
the zoom lens range.
The picture can be adjusted within the shift range of the
lens.
IN E-Z LN ADJ. EN MN
SELECT VOLUME MUTE E-ZOOM LENS ENTER MENU
INPUT
Invert Image