Sharp XG-E1200U Operation Manual page 12

How to set up the projector and screen
Cautions: When setting up the projector
Do not place it in humid or dusty places, or places where the air is sooty or full of cigarette smoke. If the lens,
mirror, or other optical components become dirty, the picture will blur or darken, making viewing difficult.
Do not expose to extreme heat or cold.
Operating temperature: 41°F to 104°F (5°C to 40°C)
Storage temperature:
Do not tilt the projector more than 5°.
Position the screen so that it is not in direct sunlight or room light. Light falling directly onto the screen washes out
colors, making viewing difficult. Close the curtains and dim the lights when using the screen in a bright or sunny
room.
The best picture will be obtained when the projector is at a 90 degree angle to the screen. Position the projector
and screen as shown.
Example of a standard setup
The projector lens should be centered
in the middle of the screen.
Using the horizontal reverse function makes the following setups possible.
Example of a reversed image setup
By placing a mirror (normal flat type) in front of the lens and using the horizontal reverse function, the image
reflected from the mirror can be projected onto the screen.
Rear projection with a rear projection screen is also possible when using the horizontal reverse function.
The projector lens should be centered
in the middle of the screen.
4°F to 140°F ( 20°C to 60°C)
TOP VIEW
Lens center
AUDIENCE SIDE
Mirror
SIDE VIEW
Lens center
If the projector and screen are not
centered properly, the picture will be
distorted, making viewing difficult.
Rear Projection
If the projector and screen are not
centered properly, the picture will be
distorted, making viewing difficult.
E-12