Select Input; Adjust The Volume - Sharp XV-380H Operation Manual

On-Screen Display For
viewing the picture
5. Select input.
Press the INPUT SELECT button to switch the picture input.
When you press the button, the current input
mode is
displayed for about
4 seconds. If you press the button again
while the input mode is displayed, the mode changes as
shown on the left.
Confirm the selected input terminal, then press the INPUT
SELECT button.
The number of displayed segments
increases or decreases as the
I
VOLUME
111..* . . . . . . . . . .
6. Adjust the volume.
Press the Volume Up-Down button on the projector or on the
remote control to adjust the volume.
MUTE
l
Press the MUTE button to temporarily turn off the sound.
l
Press the button once again to turn the sound back on.
7. Turning off the power from the projector
or remote control
When switching the unit OFF, follow these steps:
1) Press POWER button on the front panel or remote control
to the OFF position.
2) Wait approximately 90 seconds for fans to shut off.
3) Press the MAIN POWER switch OFF. (Red button.)
4) Turn power point off and remove power lead from wall
socket.
After the POWER indicator lights red and the cooling fan runs for 90
will turn off, and the projector will return to
The power can be turned on again either from the projector or
remote control. When the power is turned on, the POWER indicator
and LAMP REPLACEMENT indicator light green.
Note:
l
When the POWER is off on the projector set, the power
cannot be turned on from the remote control.
O-14
-_