Table of Contents
Advertisement
Starting appliance
7.3
Other settings for installer
In addition to the air flow, it is also possible to change other settings of the appliance; for an overview of
these settings of a standard appliance (® Setting values standard appliance page 46 ) and appliance
with Plus pcb ( ® Setting values appliance with Plus pcb page 49).
Changes can be carried out in the settings menu
7.4
Factory settings
It is possible to simultaneously revert all the changed settings back to the factory settings.
All changed settings are then back to the values they had when they left the factory; all message and fault
codes are also deleted from the service menu.
i
Note
The filter message, however, is not reset!
For returning to factory settings, open the settings menu
Under appliance settings, the appliance can be returned to factory settings through step number 15.9.
24 | WOLF GmbH
Warning:
As changes in the settings menu can disrupt the proper functioning of the appliance,
changes of settings not described here require consultation with Wolf GmbH
Incorrect settings may seriously affect the proper performance of the appliance!
.
.
xxxx
7100832_202010
Advertisement
Table of Contents
