Starting Appliance; Switching Appliance On And Off; Setting The Air Flow - Wolf CWL-2-325 Installation And Operating Instructions Manual

Starting appliance

7 Starting appliance
7.1

Switching appliance on and off

Switching on:
– Switching on the mains power:
1. Connect the 230 V power plug to the electric system.
2. During the startup of the appliance, the version of the software is displayed.
If the appliance has been without power for a long time (more than approx. 1
week), you will have to reset the correct language, time and date in setting
menu .
3. The appliance will then operate immediately after this according to the mode
of the multiple switch. If no multiple switch is connected then the appliance
operates always in mode 1.
Switching off:
– Switching off mains power:
1. Pull the 230 V power plug from the electric system; the appliance is now free
of voltage.
2. Nothing is now shown on the display.
7.2

Setting the air flow

Good ventilation contributes to healthy air in the home, optimal comfort and the proper functioning of the
installation.
The air flows of the appliance have been set in the factory as follows 50, 100, 150 and 250 m
performance and the energy consumption of the appliance depend on the pressure drop in the duct
system, as well as on the filter resistance. If these conditions are not complied with, the air flow rate of the
higher mode will automatically be adjusted.
Changes can be carried out in the settings menu
Go in the settings menu to steps 1.2 to 1.4 to adjust the air flow.
Please note!
The highest demanded ventilation mode has priority. If the external multiple switch is set to mode 3, then
the ventilation mode cannot be adjusted to a lower mode on the main screen.
An exception to this is ventilator mode 0. If mode 0 is chosen on the display: control from other switches,
sensors, etc. is not possible.
For connected CO
the measured PPM values: for a connected humidity sensor the air flow will be switched to mode 3 when
this is switched on.
7100832_202010
Warning!
When working on the appliance, always first take the voltage from the appliance by
pulling the power plug.
sensors the air flow will be steplessly controlled between mode 1 and 3 depending on
2
.
3
/h. The
WOLF GmbH | 23