Electrical Connections; Connecting The Power Plug; Connecting The Multiple Switch - Wolf CWL-2-325 Installation And Operating Instructions Manual

Installation
1 = CWL -2-325 right-hand version (place level)
2 = Preferred ventilation air supply
3 = Sewer release
4 = Preferred location of ventilation air discharge; Use insulated ventilation roof sleeve
5 = Thermally insulated piping
6 = Condensate discharge
7 = Sound absorber(s)
8 = Duct to and from house
6 = Condensater discharge
7 = Sound absorber(s)
8 = Duct to and from house
5.5

Electrical connections

5.5.1

Connecting the power plug

The appliance can be connected to an easily accessible, earthed wall socket
with the plug that is mounted to the appliance. The electric installation must
comply with the requirements of your power company.
5.5.2

Connecting the multiple switch

The multiple switch (not supplied with the appliance) is connected to the modular connector type RJ12
(connector X14) that is placed on the rear of the display cap of the appliance (®). For connection
examples of multiple switch (®). A wireless remote control (®) and a combination of multiple switches is
also possible (® Connecting extra multiple switch with filter indication page 37).
The 4-way switch can also be used to activate a 30-minutes boost mode by putting the switch to setting 3
for less than 2 seconds and directly turning it back to setting 1 or 2. The boost mode can be reset by
putting the switch to setting 3 for longerthan 2 seconds or by switching it to absence mode (
7100832_202010
xxxx
).
WOLF GmbH | 15