Eaton 20000i Manual page 29

Table 4-3 Buzzer
Priority UPS condition
1 UPS fault and failure
2 Normal mode
3 Battery/battery test mode
4 Bypass mode
5 Overload
6 Other alarm
7 Manual bypass
Note: buzzer alarm can be enable/disable by function button, if buzzer
alarm is disabled, all present alarm is muted except that the button press
still has a tick beep. Buzzer alarm will be enabled automatically once new
alarm arises.
Interface
In order to make sure all segments are OK, LCD begins to do self-test after
power on. During self-test, all the segments will be lighted for 2 seconds,
then the LCD will turn to normal display status.
Fig. 4-2 The default LCD display
Buzzer
Continuous
No beep
One beep per 4 sec
(One beep per 1s when battery low)
One beep per 2 minutes
One beep per 500ms
One beep per 1s
One beep per 1s
26