Table of Contents
Advertisement
Individual signals function in
Input 1
Input 2
Output 1 (relay)
Since the
FW version 2.79
is implemented, enabling to
module offers the
6.4.3 Wiegand input (entry reader)
The module can be configured into a mode of controlling the door from both sides
reader
mode).
In the
entry reader mode
WIEGAND interface
operates standardly, the reason codes equal zero.
When the reader module operates in the entry reader operating mode, the I/O Port (tab. 6)
is used as an output for controlling the entry reader buzzer.
Since the
FW version 2.79
is implemented, enabling to
module offers the
The
WIEGAND input
6.5 Reading synchronization
Since the
FW version 2.79
is implemented, enabling to
module offers to use the
input/output port 3
7 Useful links
•
Wiring diagrams:
•
Program equipment:
WIEGAND output
Beeper control (0 V active)
Yellow LED control (0 V active)
Tamper signaling; it follows the alarm state of tamper
sensors (tamper signal = relay switched on)
Table 14: Signal function in WIEGAND operating mode
the reading synchronization of a
cancel the mutual disturbance
Wiegand data interface synchronization
an identification at an external reader connected via the
acquires a
reason code
the reading synchronization of a
cancel the mutual disturbance
Wiegand data interface synchronization
and
WIEGAND output
the reading synchronization of a
cancel the mutual disturbance
IO synchronization
is used as the
synchronization
http://techfass.cz/diagrams-aps-400-en.html
http://techfass.cz/software-and-documentation-en.html
operating mode is described in table 14.
in
255; at the same time the reader module
in
operating modes are mutually exclusive.
in both
MASTER
signal.
Page 12
3)
couple of TECHFASS readers
of the modules. The reader
MASTER
mode.
couple of TECHFASS readers
of the modules. The reader
SLAVE
mode.
couple of TECHFASS readers
of the modules. The reader
and
SLAVE
mode. The
(entry
Advertisement
Table of Contents
