Connecting With Skip Signal (Sensor) - Mitsubishi M800S Series Connection And Set Up Manual

Hide thumbs Also See for M800S Series:

Table of Contents

M800S/M80/E80 Series Connection and Setup Manual

7 Connection of Control Unit

7.9 Connecting with Skip Signal (Sensor)

Connect the skip signals to SKIP connector of the control unit.

Skip signals are used for processing high-speed signals. Always shield the cable.

Control unit

Connecting the skip signal cable to a wrong connector causes a damage on the control unit when turning ON

the skip signal power supply. Confirm the wiring before turning the power ON.

(1) Connection of skip signal cable

<0V connection at COM terminal>

Control unit

0V connection at COM terminal

IB-1501269-J

power supply

M80 series E80 series M80w series