Preparation; Fitting/Removing Brush Heads; Brushing Teeth - Nevadent NKZ 3 A1 Operating Instructions Manual

HANDLING BATTERIES
If you do not intend to use the appliance for an extended
►
period, remove the batteries.
If the batteries have leaked, use protective gloves. Clean the
►
battery compartment and the battery contacts with a dry cloth.
Keep batteries out of the reach of children. Children might
►
put batteries into their mouth and swallow them. If a battery
is swallowed, medical assistance must be sought immediately.

Preparation

Unscrew the battery compartment cap 5.
1) Insert the batteries as per the polarity diagram
in the battery compartment.
2) Screw the battery compartment cap 5 back
on.
3) Select a sticker and stick it on the front of the
appliance.
4) Before initial use, clean the new brush heads 1
with fresh water.

Fitting/removing brush heads

Push a brush head 1 onto the hand element 4
■
with a slight twisting motion.
To remove the brush head 1, turn it a little
■
anticlockwise while pulling it upwards and off .
NOTE
To avoid damage to the appliance, always use
original brush heads.
(See section "Order replacement parts" for
replacement brush heads)
■ 4 │ GB │ IE │ NI

Brushing teeth

WARNING!
Due to the unaccustomed eff ect of the tooth-
brush, there may be some initial gum bleeding.
This is normal. If this continues for more than
two weeks, you should consult your dentist.
1) Place the brush head 1 onto the drive shaft
on the handset 4.
2) Moisten the brush under fl owing water.
3) Put a little toothpaste onto the wet brush.
NOTE
To avoid spray, do not switch on the appliance
until it is in your mouth
4) Turn the sandglass 6 over and press the on
switch 2.
NKZ 3 A1