Wagon Components - HORST WAGONS CONTOUR CHCFRF30 Operator's Manual

Wagon Components:

Inspect wagon components monthly. Unusual play or noise could be an
indication of worn parts. Parts replacement should be performed by qualified
personnel.
Wagon components should be lubricated / greased yearly, locate the grease
zerks shown in the illustrations below.
• Lubricate with an good Lithium EP2 grease or equivalent.
• Use a hand-held grease gun for all greasing, one shot of grease is adequate
• Wipe grease zerk with a clean cloth before greasing, to avoid injecting dirt and grit.
• Replace broken zerk fitting immediately.
• If grease zerk will not take grease, remove and clean thoroughly. Also clean lubricant passageway. Replace fittings if
necessary.
B
E
A
B
A
Steering Spindles
D
Suspension Pivot Steering Pivot
A
D
B
C
D
Wagon Rear
B
Tie Rod End Tie Rod End
E
Tongue Pivot
A
C
Wheel Bolts: check
on a daily basis.
See wheel torque
chart
C
Lightly
lubricate the
tongue lock:
must move
freely
F
CAUTION
!
Operational Hazard
Chock wheels
performing maintenance
on the wagon to prevent
unwanted movement
C
E
C
B
D
check on a regular
basis: see tire pressure
Lightly lubricate the
tongue pullout: must
move freely
when
SNL00002
A
D
F
Wagon Front
Tire Pressure:
chart
Lightly
lubricate the
coupler: must
move freely
37