Universal Header Pad Configurations; Basic Configurations; Base Pad; Large Pad For Draper Head - HORST WAGONS CONTOUR CHCFRF30 Operator's Manual

Universal Header Pad Configurations

5 Basic Configurations:

• Base Pad - low profile corn head
• Large Pad - for most draper heads
• High Back Pad - for flex draper head
• Low Back Pad - for standard cutting platform
• Low Back - for standard corn head
Follow the instructions below to adjust and set up your
universal header pads for your particular header.

Base Pad

Ideal for low profile corn heads or combines with lift height
limitations.
• Remove the hitch pins and slide out the shoe heal
pins.
• Remove the upper shoe assembly,
• Reassemble the shoe heal pins to the upper shoe
assembly for storage.
• Ensure the hitch pins are securely in place.
• Release the shoe lock handle and locate base pad on
rail to desired position, lock the handle.
• In some applications installing one pin in the alternate
pin location may be desirable to keep head from
sliding.

Large Pad for Draper Head

• Remove the hitch pins and slide out the lower locking
(short) and locking pin (long).
• Swing the two corn head plates 180 degrees to the
open position, and reassemble with the lower locking
pin.
• Ensure the hitch pin is securely in place.
• Release the shoe lock handle and locate base pad on
rail to desired position, lock the handle.
WARNING
!
Operational Hazard
Ensure locking & heal pins are secured with
hitch pins. If a hitch pin is lost or damaged,
replace only with the same style hitch pin.
Hitch Pin
Shoe Heal Pin
Locking Pin - Long Locking Pin - Long
Upper Shoe Assembly
Alternate Pin Location
Lower Shoe Assembly
Corn Head Plate Corn Head Plate
Lower Locking Pin - Short Lower Locking Pin - Short
Hitch Pin Hitch Pin
17