Ratchet Strap System; Release The Strap From The Ratchet; To Tighten The Strap - HORST WAGONS CONTOUR CHCFRF30 Operator's Manual

Ratchet Strap System

There are two 50mm (2.0") wide, sliding ratchet straps
included with the header wagon. They are fully re-
positionable anywhere along the bottom rail. Once in your
selected position, follow the points below to release or
tighten the strap.

Release the strap from the ratchet:

• Pull up on the centre latch, and move the handle up
out of the lock position, to the upper stop
• Pull up on the centre latch, and move the handle
past the stop, and the ratchet will release.
• Pull out as much strap as you need.

To tighten the strap:

• Attach the end of the strap to a secure location
• Pull up on the centre latch and pull the handle
down to engage the ratchet, and begin ratcheting,
continue to pull the handle up and down.
• When the strap is tight, pull up on the centre latch,
lower the handle into the lock position.
• Ensure the handle is locked before proceeding
with transport.
Ratchet Strap Specifications
Strap
Hook Type
Size
Double "J" 50mm
Hook (2.0")
WARNING
!
Operational Hazard
Be sure to inspect the ratchet and strap for
excessive wear or damage each time they are
put in use. Replace if worn or damaged.
20
Work Load Breaking
Limit Strength
1511 kg 4535 kg
(3333 lb) (10,000 lb)
Centre Latch
Release
Tighten
WARNING
!
Drop Hazard
Be aware that an unsecured
load may fall from the wagon.
Proceed with caution until the
load has been secured.
WARNING
!
Pinch Point Hazard
When strapping, be aware of pinch points at
the hitch point, and ratchet handle.
Strap Release Position Strap Release Position
Handle Lock Position Handle Lock Position
Handle Lock Position
SL00006