Mo-vis coot Control R-net Installation Manual page 23

When you press S6 for more than 2 seconds, you scroll through the profiles
and the modes. You can drive in every profile and you can change the seating
positions.
To change the seating positions with the Scoot Control:
• Press S6 for more than 2 seconds. You will now scroll through the
profiles and the modes. Stop at the seating mode.
• In the seating mode, you can scroll through the different actuators by
pressing the handlebar gently. Stop at the desired actuator.
• Move the actuator by pushing the left and right throttle (the actuator
will move up/down according to the settings of both throttles).
Using the Scoot Control as Universal Input Device Type, but limiting
access to the modes
It is possible that you want to use the Scoot Control as a Universal joystick,
but you want the user but not the attendant to have access to the seating
positions.
In that case, proceed as follows:
• Make sure that Controls > Global > Profile Button is set to Profiles/
Modes in R-net.
• Change parameter 4 to Profile: see
25 .
22
On-board configuration on page
Scoot Control Installation manual