Mo-vis coot Control R-net Installation Manual page 22

By default the parameter Controls > Global > Profile Button is set to Profiles/
Modes in R-net.
NOTE: When you use the Scoot Control as Attendant Input Device
Type, the attendant does not have direct access to the modes. If the
attendant wants to adjust the lifts of the power chair, you will have to
add an external Curtiss-Wright CJSM2 compatible Actuator Keypad (see
Actuator Keypad on page 17
Using the Scoot Control as Universal Input Device Type
If the attendant wants access to the modes, then you have to set the Scoot
Control as Universal joystick.
To achieve this, proceed as follows:
• In R-net, set Profile Management > Input Device Type to Universal.
• Change parameter 5 to Universal: see
25 .
NOTE: It is very important that you change the settings both in the
Scoot Control (on-board configuration) and in R-net. Otherwise the
Scoot Control will not function properly.
If the Scoot Control is set as Universal, then the Scoot Control will always
start up in the last used profile.
Scoot Control Installation manual
).
On-board configuration on page
21