Connecting A Smart Device And Printer Directly (Wi-Fi Direct) - Epson ET-2810 Series User Manual

Adding or Replacing the Computer or Devices
Making Wi-Fi Settings by PIN Code Setup (WPS)
You can connect to an wireless router by using a PIN code that is printed on the network status sheet. You can use
this method to set up if an wireless router is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a
PIN code into the wireless router.
1. Load papers.
2. Hold down the
button on the printer for at least seven seconds.
The network status sheet is printed.
3. While holding down the
alternately.
4. Use your computer to enter the PIN code (an eight digit number) printed on [WPS-PIN Code] column of the
network status sheet into the wireless router within two minutes.
When a connection is established, the
Note:
❏ See the documentation provided with your wireless router for details on entering a PIN code.
❏ The printer is in a connection error status when the
clearing the printer error by pressing the
printer and try again. If it still does not work, print a network connection report and check the solution.
Related Information
"Printing a Network Status Sheet" on page 160
&
"Checking the Network Connection Status" on page 154
&
"Printing a Network Connection Report" on page 155
&
Connecting a Smart Device and Printer Directly (Wi-Fi
Direct)
Wi-Fi Direct (Simple AP) allows you to connect a smart device directly to the printer without a wireless router and
print from the smart device.
button, press the button until the
light turns on.
button on the printer, reboot the wireless router, place it close to the
152
>
Connecting a Smart Device and Printer Directly (Wi
light and the
light and the light flash simultaneously. After
...
light flash