Epson ET-2810 Series User Manual page 119

Solving Problems
Light Status
The printer is connected to a wireless (Wi-Fi) network.
The printer is connected to a network in Wi-Fi Direct (Simple AP) mode.
Error Status
When an error occurs, the light turns on or flashes. Details of the error are displayed on the computer screen.
/ : On
/ : Flashing
Light Status
Wi-Fi connection error has occurred.
Initial ink charging may not be complete.
No paper is loaded or more than one sheet
has been fed at a time.
A paper jam has occurred.
❏ The printer was not turned off correctly.*
❏ Because the printer was turned off while
operating, the nozzles may have dried
and clogged.
* The power was turned off with a power
strip or breaker, the plug was pulled out of
the outlet, or an electrical failure occurred.
>
Checking Lights and Printer Status
Solutions
Press the button to clear the error and try again.
See the Start Here poster to complete initial ink
charging.
Load paper and press the
Remove the paper and press the
If the paper jam error continues after removing the
paper and turning the power off and on again, paper
may remain inside the printer. Load A4 size paper in
the rear paper feeder, and then press the
button to remove the paper inside. Load paper in the
portrait direction.
If the error cannot be cleared, contact Epson support.
❏ After clearing the error by pressing the
button, we recommend performing a nozzle
check. Cancel any pending print jobs.
❏ To turn off the printer, make sure you press the
button.
119
or button.
or button.
or
or
P