Important Safety Instructions - ELECTROCOMPANIET AW 300 Owner's Manual

1. Read all the safety and operating instruc-
tions before operating this product.
2. Keep these instructions for future reference.
3. Adhere to all warnings on the product and
in the operating instructions.
4. Follow all operating and use instructions.
5. Do not use this product near water.
6. Clean only with dry cloth. Clean only the
outside of the product.
7. Only use attachments/accessories specified
by the manufacturer.
8. Replace only with same type fuse.
9. Do not block or cover any ventilation open-
ings. Install in accordance with the manufac-
turer's instructions. This product should not
be placed in a built-in installation such as a
bookcase or rack unless proper ventilation is
provided.
10. Do not install near any heat sources such
as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.
11. Before connecting the AC power supply
cord to the product, make sure the voltage
selector switch or switches correspond to the
local electrical supply. If you are unsure of your
electrical supply voltage, contact your local
power supply company. The acceptable power
input range is either 100-120 VAC or
200-240 VAC 50/60 Hz.
12. Do not defeat the safety purpose of the
polarized or grounding-type plug. US power
plugs (NEMA5-15) only: A polarized plug
has two blades with one wider than the other.
A grounding type plug has two blades and
a third grounding prong. The wide blade or
the third prong are provided for your safety. If
the provided plug does not fit into your outlet,
consult an electrician for replacement of the
obsolete outlet.

Important safety instructions

13. Protect the power supply cord from being
walked on or pinched particularly at plugs,
convenience receptacles, and the point where
they exit from the product. Do not pull on the
power supply cord.
14. The mains plug of the power supply cord
shall remain readily operable.
15. Unplug this product during lightning storms
or when unused for long periods of time.
16. To completely disconnect this product from
the mains, disconnect the power supply cord
plug from the receptacle.
17. Refer all servicing to qualified service
personnel. Servicing is required when the
product has been damaged in any way, liquid
has been spilled or objects have fallen into the
product, the product has been exposed to rain
or moisture, does not operate normally, or has
been dropped.
18. To reduce the risk of electrical shock, do
not open the product. Refer all disassembling
to qualified service personnel.
19. To reduce the risk of fire or electric shock,
this product should not be exposed to rain or
moisture and objects filled with liquids, such as
vases, should not be placed on this product.
20. No naked flame sources, such as lighted
candles, should be placed on the product.
21. Any terminals marked with the pre-
ceding symbol are HAZARDOUS LIVE
and any wiring connected to these termi-
nals must be installed by an INSTRUCTED
PERSON or with ready-made leads or cords.
22. Condensation may occur when moving the
product from a cold to a warm location, or
vice versa. Should this occur, the product may
not operate properly. In such a case do not
apply power to the product, instead let the
product sit at room temperature for a few
hours to facilitate moisture evaporation.
3