Table of Contents
Advertisement
CONTROL PANEL
7.6.3
CHANGING THE ROTATION DIRECTION
The keypad direction submenu shows the rotation direction of the motor. In this submenu,
you can also change the rotation direction. To make the motor to agree with the set rotation
direction, select the keypad as the control place.
1
In the Keypad control menu (M3), find the Keypad
direction with the Menu buttons Up and Down.
2
To go to the edit mode, push the Menu button Right.
3
Select the direction with Menu buttons Up and
Down.
NOTE!
For more information on how to control the motor with the keypad, see Chapters
7.1 Control keypad and 8.2 Commissioning of the drive.
7.6.4
DISABLING THE STOP MOTOR FUNCTION
As a default, the motor stops when you push the STOP button no matter what is the control
place.
1
In the Keypad control menu (M3), find the page 3.4.
Stop button with the Browser buttons.
2
To go to the edit mode, push the Menu button Right.
3
To select Yes or No, use the Browser buttons.
4
Accept the selection with the Enter button.
When the Stop motor function is not active, the STOP button stops the motor only when the
keypad is the control place.
7.6.5
SPECIAL FUNCTIONS IN THE KEYPAD CONTROL MENU
There are some special functions that you can do in menu M3.
NOTE!
If you are in other menu than M3, the special functions are not available. In other
menu than M3, when the keypad is not the active control place and you push the
start button, you get an error message Keypad Control NOT ACTIVE.
SELECTING THE KEYPAD AS THE CONTROL PLACE
1
You have 2 options:
Keep the START button pushed down for 3
•
seconds when the motor is in RUN state.
Keep the STOP button pushed down for 3
•
seconds when the motor is stopped.
The keypad is selected as the control place and the
current frequency reference and direction is copied
to the keypad.
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
VACON · 87
7
Advertisement
Table of Contents
