Installing A Rear Module; Installing The Card - Opengear SPG-8260 User Manual

Installing a Rear Module

If you are installing the card in a DFR-8310-BNC frame, or the Rear Module is already installed,
proceed to "Installing the Card".
To install a rear module in your openGear frame
1. Locate the card frame slots on the rear of the frame.
2. Remove the Blank Plate from the slot you have chosen for the card installation.
3. Install the bottom of the Rear Module in the Module Seating Slot at the base of the frame's
back plane.
4. Align the top hole of the Rear Module with the screw on the top-edge of the frame back plane.
5. Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back plane of
the frame. Do not over tighten.
6. Ensure proper frame cooling and ventilation by having all rear frame slots covered with Rear
Modules or Blank Plates.

Installing the Card

Use the following procedure to install the card in an openGear frame:
1. Locate the Rear Module you installed in "Installing a Rear Module".
2. Hold the card by the edges and carefully align the card-edges with the slots in the frame.
3. Fully insert the card into the frame until the rear connection is properly seated in the Rear
Module.
4. Affix the supplied Rear Module Label to the BNC area of the Rear Module.
20 • Physical Installation
Screw Hole
Module Seating Slots
SPG-8260(-W) User Guide (v5.0)