Engine Maintenance; Servicing The Air Cleaner - Toro 30864A Operator's Manual

•
Brake pedal (1) (Figure
Figure 54
•
Cutting unit spindle shaft bearings (2 per cutting
unit) (Figure 55)
Note:
Either fitting can be used, which ever is
more accessible. Pump grease into the fitting until
a small amount appears at bottom of the spindle
housing (under the deck).
Figure 55
•
Rear roller bearings (2 per cutting unit)
Figure 56
Note:
Make sure the grease groove in each roller
mount aligns with the grease hole in each end of
the roller shaft. To help align the groove and hole,
there is also an alignment mark on one end of the
roller shaft.
54)
g008906
(Figure
g008907

Engine Maintenance

Servicing the Air Cleaner

Check the air cleaner body for damage which could
cause an air leak. Replace if damaged. Check the
whole intake system for leaks, damage or loose hose
clamps.
g011615
Service the air cleaner filter only when the service
indicator (Figure
before it is necessary only increases the chance of
dirt entering the engine when the filter is removed.
Important:
Be sure the cover is seated correctly
and seals with the air cleaner body.
1. Release the latches securing the air cleaner
cover to the air cleaner body
1. Air cleaner cover
56)
2. Air cleaner cover latch
2. Remove the cover from the air cleaner body.
Before removing the filter, use low pressure air
(40 psi, clean and dry) to help remove large
accumulations of debris packed between outside
of the filter and the canister. Avoid using high
pressure air which could force dirt through
the filter into the intake tract.
This cleaning process prevents debris from
migrating into the intake when the filter is
removed.
3. Remove and replace the filter
Cleaning of the used element is not
recommended due to the possibility of damage
to the filter media. Inspect the new filter for
shipping damage, checking the sealing end of
the filter and the body. Do not use a damaged
element. Insert the new filter by applying
pressure to the outer rim of the element to seat
it in the canister. Do not apply pressure to the
flexible center of the filter.
44
57) requires it. Changing the air filter
(Figure
Figure 57
3. Air cleaner service
indicator
(Figure
57).
g021217
58).