Cleaning And Maintenance - cecotec THERMOSENSE 390 CLEAR Instruction Manual

temperature for 3 minutes.
3. When water boils during the set time, you will hear a sound and the water purification
process will be over.
Temperature control
Press the start button once to boil water or press the power button to select the temperature:
- 60 ºC: The LED light turns green.
- 70 ºC: The LED light turns blue.
- 80 ºC: The LED light turns yellow.
- 90 ºC: The LED light turns purple.
Keep warm function
1. Press the start button for 2 seconds. The kettle will enter the keep warm function and the
red LED light will blink.
2. When the water boils, the kettle will keep the temperature for 2 hours. During this time, if
the temperature drops below 85 ºC, the kettle will heat to keep it warmer.
3. Press the start button for 2 seconds and press the button 1 to 4 times depending on the
temperature you want to select. A light will blink in its corresponding colour according to
the selected temperature. The kettle will keep water warm for 2 hours.
Warning
- Water can only be kept warm under this mode. This function will be deactivated when the
kettle body is taken away from the base.
- Unplug the product from the power outlet when you have finished using it.

4. CLEANING AND MAINTENANCE

- Always disconnect the plug from the mains supply before cleaning the machine.
- The exterior of the jar can be cleaned with a slightly dampened cloth.
- Do not use abrasive products.
- The calc filter can be removed for cleaning when the water cools down.
- In case the water used has caused minerals to build up, such as calc, it is suggested to fill
half the kettle with water and lemon juice (or 3 tbsp. of vinegar) and boil it. If impurities are
still left after this, repeat the process for 15 minutes. Allow it to cool down before emptying
and rinsing it.
THERMOSENSE 390 CLEAR
ENGLISH
37