Parts And Components; Before Use; Operation - cecotec THERMOSENSE 390 CLEAR Instruction Manual

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. Anti-calc filter
2. Jar
3. Fabric filter
4. Base
5. LCD display
6. Cable

2. BEFORE USE

- Before using the product for the first time, boil water twice without cleaning agents and
then throw water away.
- The kettle should always be unplugged when filling or adding water.
- Fill the kettle with water to the desired level. Do not exceed the max. mark. Use the water
level indicator. You can fill via the spout or opening the lid.
- Warning: Do not forget to close the lid properly after filling the kettle with water, otherwise
it will not stop automatically after operating.
- Do not fill it with less than 0.5L of water. Always from the MIN. mark to prevent the kettle
running dry while operating.
- Do not fill it over 1.7L of water. Do not exceed the MAX. indicator.
- An automatic safety system has been installed for protection against overheating. It
will be efficient if the kettle is switched on with insufficient water. If the safety system
activates, disconnect the kettle from the power outlet and allow the kettle to cool down
for 5 or 10 minutes. Refill it and it will work normally.
- After boiling the machine switches off automatically.
- Disconnect the kettle from the power supply.
- Do not open the lid when pouring.
- If the kettle is overfilled, boiling water may be ejected.

3. OPERATION

Press the power button, you will hear a sound and a red light will turn on. The product will start
running. While water is boiling, the indicator light will turn off and beep.
Pure function
1. Press the power button, you will hear a sound and the product will start running.
2. Then press the button to start purifying water. This function allows keeping the
microbiological quality of water by submitting water to a primary disinfection with a high
36 THERMOSENSE 390 CLEAR