The "Channels" Menu - Sennheiser EK 1039-DW Manual

Hide thumbs

Table Of Contents

Table of Contents

Configuring the receiver

C o p y

max. 10 cm

Copying the receiver settings to additional receivers – "Copy"

Setup

Copy

Call up "Copy"

Deactivates the function

Via the "Copy" menu item, you can copy all settings of one receiver (A) to an

arbitrary number of other EK 1039 receivers (B). This allows you to quickly

and easily transfer e.g. a new receiving channel to all other receivers in the

system.

To prepare the receiver (A) to transfer the settings:

Select a receiver.

Set the desired receiving channel, the name, the squelch threshold, etc.

Change to the "Copy" menu item.

All settings of this receiver (A) will be transferred to the other receivers

(B).

To prepare the receivers (B) to receive the settings:

Open the battery compartment cover of all receivers (B) to which you

want to transfer the settings.

Switch on all receivers.

To copy the settings:

Place the receiver (A) above the infra-red interfaces

receivers (B), one after the other. The distance between the infra-red

interfaces must not exceed 10 cm.

The settings are copied and "Copy" briefly appears on the display panels

of the receivers (B). If data transfer was successful, the receiver (B)

switches off automatically.

Strong extraneous light may interfere with the data transfer via the

infra-red interface. Therefore, position the receivers so that any

possible interference caused by extraneous light is avoided. The

blue line between the infra-red interfaces

left indicates the direction from which the IR radiation must impinge

upon the receiver.

If you are using receivers from different frequency ranges and if you

have set a frequency that is not available in the frequency range of

the receiver (B),

panel.

Use receivers from the same frequency range or set a frequency

that is available in both frequency ranges.