Table of Contents
Advertisement
Configuring the receiver
20 |
Tourguide 1039
Via the "Channels" menu, you can call up the
submenu.
The
"Setup Ch
1" ...
Entering a name – "Name"
Name
Setup Ch 2
Name
W
n g l i s h
W n g l i s h
Call up "Name"
Enter a character
and confirm
"Stored"
Via the "Name" menu, you can enter a freely selectable name for the
receiving channel (e.g. the language of the guided tour). The name is dis-
played on the standard display and can consist of up to 8 characters such as:
•
letters (without pronounciation marks),
•
numbers from 0 to 9,
•
special characters and spaces.
To enter a name, proceed as follows:
Press the rocker button to select a character.
SET
Press the
SET
button to change to the next segment/character
or to store the complete entry.
Changing the receiving frequencies of the channels – "Tune"
SET
Setup Ch 2
Tu n e
Tune
864.500 MHz
863.500 MHz
Call up "Tune"
Select the MHz
value and confirm
"Stored"
It is vital to observe the notes on frequency selection in the chapter
"Matching the transmitter to the receiver" on page 22.
Via the "Tune" menu item, you can change the receiving frequency of a
channel.
The receiver's channels have been factory-preset to receiving frequencies
that are intermodulation-free. However, you can change the factory-preset
frequencies. Within one frequency range, up to 32 transmission links can be
operated simultaneously.
To change the receiving frequency of the channel:
Press the rocker button to adjust the frequency in MHz steps.
SET
Press the
SET
quency.
The kHz section of the frequency is highlighted.
Press the rocker button to adjust the frequency in 25 kHz steps.
SET
Press the
SET
button to store the setting.
"Stored" appears on the display panel.
"Setup Ch
"Setup Ch
32" menu
Name
English
Enter a character;
store the setting
SET
Tu n e
864.300
MHz
Select the kHz value;
store the setting
SET
button to confirm the MHz setting of the fre-
1" ...
"Setup Ch
32"
Advertisement
Table of Contents
