SK 100 G2 bodypack transmitter · · ³ » ¹ ¸ ¿ µ ´ ² ¶ º ¾ Operating controls LC display panel Microphone/line input (MIC/LINE), Alphanumeric display ³ 3.5 mm jack socket “B.CH“ – appears when the channel bank and the Antenna channel number are displayed ·...
! the received transmitter has been muted (with the pilot tone transmission or evaluation activated). EM 100 G2 EK 100 G2 RF signal indication (EK 100 G2 only) The green LED (RF) at the front of the EK 100 G2 lights up when an RF sig- nal is being received. ¿...
Page 4
41). The diversity display indicates whether diversity section I (i.e. antenna 1) or diversity section II (i.e. antenna 2) is active. Display backlighting (EK 100 G2 only) After pressing a button, the display remains backlit for approx. 15 seconds.
Indications and displays on the transmitters Operation and battery status indication The red LED (LOW BAT/ON) provides information on the current operating state of the transmitter: Red LED lit up: The transmitter is switched on and the capacity of the batteries/accupack BA 2015 is sufficient.
The operating menu A special feature of the Sennheiser ew 100 G2 series is the similar, intuitive operation. As a result, the units are easy to operate and adjustments to the settings can be made quickly and “without looking” – even in stressful situati- ons, for example on stage or during a live show or presentation.
After switching the unit on, the standard display is shown on the display panel. EM 100 G2 EK 100 G2 Getting into the operating menu Press the button to get from the standard display into the operating menu. The last menu selected flashes on the display.
Page 8
AF OUT Setting the audio output Current audio output (in steps of 6 dB): level level EM 100 G2: 18...0...-24 dB EK 100 G2: 12...0...-30 dB Stores the setting STORED SQELCH Setting the squelch Current squelch LO, MID, HI threshold...
Page 9
NAME NAME DISPLY Switching between the Current standard display : Select standard standard displays display EM 100 G2: FREQ, NAME EK 100 G2: FREQ, NAME, CHAN STORED Stores the setting NAME VOCAL GUCAL Assigning the receiver Current receiver name Enter a name...
Page 10
Operating menu of the transmitters EXIT BANK BANK BANK Current channel bank 1...8, U (User Changing the channel bank Bank) Stores the setting STORED 1.02 1.03 CHAN B.CH B.CH Current channel (display Channel 01...04 Changing the channel depends on "DISPLY" Stores the setting setting) STORED...
Page 11
DISPLY NAME VOCAL GUCAL Assigning the Current transmitter name Transmitter name transmitter a name (6 characters) Letters w/o pronounciation marks, numbers from 0...9, special characters, spaces STORED SET: 5 x next character, then store RST. RST. RESET Security check OK, NO Loading the factory- preset default settings "reset"...