Roland EV-1-WL Connection Manual page 17

EV-1-WL Connection Guide
Configuring the Parameters to be
Controlled by the EV-1-WL
1.
From SYSTEM in the AC-22LX Editor, display the FOOT SW/
PEDAL SETTING screen.
2.
Configure the parameters to be controlled by the EV-1-WL.
CTL1 SW, CTL2 SW
These are the settings for operating the footswitch (FS-5U, FS-6 or
FS-7, sold separately) connected to the EV-1-WL.
Value Explanation
Alternately switches between two patches that you set
MEMORY
in MEMORY 1/2 ASSIGN.
Controls the looper REC, PLAY, DUB, STOP and ERASE
LOOPER
operations.
GUITAR/INST REV/ Switches the REV/REV&CHO of the GUITAR/INSTRUMENT
CHO : OFF/ON on/off.
MIC REVERB : OFF/
Switches the REVERB of the MIC on/off.
ON
RHYTHM BOX
Starts/stops the rhythm box.
START/STOP
RHYTHM BOX TAP Uses tap tempo for the rhythm box.
MUSIC APP :
Starts/stops the playback of the music app on your
START/STOP mobile device..
OFF Nothing is set.
Connection of CTL1, 2 terminals
FS-5U x 2 FS-5U x 1
Stereo 1/4" phone type 1/4" phone type
1/4" phone type x 2 1/4" phone type
TIP RING
CTL 1 CTL 2
17
Pin assignment
CTL 1, 2 jack
FS-6
Stereo 1/4" phone type
Stereo 1/4" phone type
CTL 1 CTL 2 CTL 1
FS-7
Stereo 1/4" phone type
Stereo 1/4" phone type
CTL 2
CTL 1