Table of Contents
Advertisement
10. Have a second person hold the Handlebar (7)
near the Handlebar Carriage (99).
Locate the remaining wire tie in the Handlebar
Carriage (99). Tie the indicated end of the wire
tie to the two wires on the Handlebar (7).
Next, pull the other end of the wire tie until the
two wires are routed through the Handlebar
Carriage (99). Then, untie and discard the wire
tie.
11. Loosen the Handlebar Knob (95). Next, slide
the Handlebar Carriage (99) forward as far as
possible. Then, tighten the Handlebar Knob.
Tip: Avoid pinching the wires. Attach the
Handlebar (7) to the Handlebar Carriage (99)
with four M6 x 20mm Screws (103); start all the
Screws, and then tighten them.
12. Hold the Console Bracket (33) near the
Handlebar Carriage (99). Insert the Main Wire
(68) and the two wires from the Handlebar (7)
upward through the Console Bracket.
Tip: Avoid pinching the wires. Attach the
Console Bracket (33) to the Handlebar Carriage
(99) with three M6 x 16mm Screws (107); start
all the Screws, and then tighten them.
Then, press the Wire Cover (32) onto the
Console Bracket (33).
10
7
Wire Tie
11
103
7
99
12
Avoid pinching
the wires
107
7
12
99
Avoid pinching
the wires
95
Wires
32
68
33
99
107
Advertisement
Table of Contents
