Table of Contents
Advertisement
5.5.1
Adjusting rear suspension spring
preload
Adjust the spring preload by means of the two ring nuts
(A and B) shown in the figure. Unloose the ring nut (A)
and adjust the preload using the ring nut (B).
Turn clockwise for a stiffer preload.
Turn anticlockwise for a softer preload.
Once the adjustment is over, tighten the ring nut (A).
5.5.2
Adjusting rear suspension rebound
damper hydraulic device
Adjusting of the rebound damper hydraulic device is made
in jerks. Turn the rule (C) clockwise to increase the
braking action, or turn anticlockwise to decrease it.
REAR SUSPENSION
Spring length
Rebound damper
Spring Preloading
NOTE:
Adjusting of the preload starts from the damper
spring length of 140 mm (5.55 in).
The compression and rebound adjustment starts
from the "all close" position (direction +).
Tornado Naked Tre 1130
Tornado Naked Tre 1130
Standard configuration
140 mm (5.55 in)
12 clicks
14 mm (0.55 in)
https://www.motorcycle-manual.com/
49
140 mm
50
Advertisement
Table of Contents
