Adjusting Rear Suspension Spring Preload; Adjusting Rear Suspension Rebound Damper Hydraulic Device; Adjusting Rear Suspension Compression 6.10 Damper Hydraulic Device; Hydraulic Compression Braking System At High-Speed Back - Wheel Suspension - Benelli Tornado TRE1130 Owner's Manual

5.6.1 Adjusting rear suspension spring
preload
Adjust the spring preload by means of the two ring nuts
(A and B) shown in the figure. Unloose the ring nut (A)
and adjust the preload using the ring nut (B).
Turn clockwise for a stiffer preload.
Turn anticlockwise for a softer preload.
Once the adjustment is over, tighten the ring nut (A).
5.6.2 Adjusting rear suspension rebound
damper hydraulic device
Adjusting of the rebound damper hydraulic device is made
in jerks. Turn the rule (C) clockwise to increase the
braking action, or turn anticlockwise to decrease it.
5.6.3 Adjusting rear suspension compression
damper hydraulic device
Adjusting of the compression damper is made in jerks.
Turn the rule (D) clockwise to increase the braking action,
or turn anticlockwise to decrease it.
5.6.4 Hydraulic compression braking system at
high-speed back - wheel suspension
Adjusting of the compression damper is made in jerks.
Turn the rule (E) clockwise to increase the braking action,
or turn anticlockwise to decrease it.
Tornado Tre 1130
Tornado Tre 1130
E
49
50