Chapter 2 Setup and Operation Procedures
2.3 Checking the Setting Information
2.3.2
Setting Information of the Key Management Function for the Partition
To check the setting information of the key management function for each partition, follow the procedure
below.
Procedure
1
Log in to the remote panel.
2
Move to the [Status > Security] screen.
In [Partition Encryption Status] > [Partitions], if "LT Encryption" is displayed for [Encryption
Configuration], the key management function is enabled. If "Controlled by Backup Applica-
tion" is displayed for [Encryption Configuration], the key management function is disabled,
and the key management function follows the backup software setting.
Figure 2.41 [Status > Security > Partition Encryption Status] screen
FUJITSU Storage ETERNUS LT140 Tape Library Key Management Function Option User's Guide
60
Copyright 2019 FUJITSU LIMITED
End of procedure
P3AG-3762-02ENZ0