Enabling The Link Test - Sun Microsystems Sun Ultra 2 Series Reference Manual

2.6

Enabling the Link Test

1. If you do not see the ok prompt, press the Stop (L1)-a keys.
2. At the ok prompt, type:
ok printenv tpe-link-test?
tpe-link-test?
ok
The above screen shows the current link test state (false, or disabled), followed by
the default state (true, or enabled).
1. To enable the host's link test function, type the following commands:
ok setenv tpe-link-test? true
tpe-link-test? =
ok reset-all
2. Boot the host and verify that the transceiver cable problem messages do not
appear. Type either boot net or boot disk and press Return.
2-6 Sun Ultra 2 Series Reference Manual • May 1996
false
true
true