Step 3. Tension Adjustment Of The Door Spring; Step 4. Dishwasher Installation Steps - Scandomestic SFO 3806 W User Manual

Step 3. Tension adjustment of the door spring

The door springs are set at the factory to the proper tension
for the outer door. If aesthetic wooden panel are installed,
you will have to adjust the door spring tension. Rotate the
adjusting screw to drive the adjustor to strain or relax the
steel cable.
Door spring tension is correct when the door remains
horizontal in the fully opened position, yet rises to a close
with the slight lift of a finger.

Step 4. Dishwasher installation steps

Please refer to the specified installation steps in the installation
drawings.
Affix the condensation strip under the work surface of cabinet. Please ensure the
condensation strip is flush with edge of work surface. (Step 2)
Connect the inlet hose to the cold water supply.
Connect the drain hose.
Connect the power cord.
Place the dishwasher into the cabinet
Level the dishwasher. The rear foot can be adjusted from the front of the dishwasher by
turning the Philips screw driver in the middle of the base of dishwasher use an Philips
screw driver. To adjust the front feet, use a flat screw driver and turn the front feet until
the dishwasher is level. (Step 5 to S
Install the furniture door to the outer door of the dishwasher. (Step 7 to Step 10)