Appendix; S A F E T Y I N S T R U C T I O N; G E N E R A - ATEN CS1148H-AT-U User Manual

ATEN Secure KVM User Manual
Safety Instructions
General
� This product is for indoor use only.
� Read all of these instructions. Save them for future reference.
� Follow all warnings and instructions marked on the device.
� Do not place the device on any unstable surface (cart, stand, table, etc.). If the device falls, serious
damage will result.
� Do not use the device near water.
� Do not place the device near, or over, radiators or heat registers.
� The device cabinet is provided with slots and openings to allow for adequate ventilation*.To ensure
reliable operation, and to protect against overheating, the cabinet must never be blocked or covered.
� The device should never be placed on a soft surface (bed, sofa, rug, etc.) as this will block its
ventilation openings*. Placing devices without slots or openings on a soft surface will affect the heat
dissipation.
� The device should not be placed in a built in enclosure unless adequate ventilation has been
provided.
� Never spill liquid of any kind on the device.
� Unplug the device from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a
damp cloth for cleaning.
� The device should be operated from the type of power source indicated on the marking label. If you
are not sure of the type of power available, consult your dealer or local power company.
� The device is designed for IT power distribution systems with 230V phase-to-phase voltage.
� To prevent damage to your installation it is important that all devices are properly grounded.
� The device is equipped with a 3-wire grounding type plug. This is a safety feature. If you are unable
to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not attempt
to defeat the purpose of the grounding-type plug. Always follow your local/national wiring codes.
� Do not allow anything to rest on the power cord or cables. Route the power cord and cables so that
they cannot be stepped on or tripped over.
� If an extension cord is used with this device make sure that the total of the ampere ratings of all
products used on this cord does not exceed the extension cord ampere rating. Make sure that the total of
all products plugged into the wall outlet does not exceed 15 amperes.
� To help protect your system from sudden, transient increases and decreases in electrical power, use a
surge suppressor, line conditioner, or uninterruptible power supply (UPS).
� Position system cables and power cables carefully; Be sure that nothing rests on any cables.
� Never push objects of any kind into or through cabinet slots. They may touch dangerous voltage
points or short out parts resulting in a risk of fire or electrical shock.

Appendix

21