Specifications - Strong SRT SRT 43UC6433 User Manual

Problem
Playback of video is
causing picture freeze/
macro blocks or similar
distortion, especially on
HD content
No signal or weak signal,
intermittent reception
Bad picture/blocking
error during heavy rain
If the TV turns off after
plugging a cable into
any connector
NOTE:

10.0 SPECIFICATIONS

Audio
Audio Output:
Video
Channel coverage:
System:
Connectors 43", 50"
1x ANT IN
28
Read/write speed of your USB device could be too low. Make sure to use a
USB storage device with sufficient speed and space. Pen drives (USB sticks)
may not support sufficient speed.
a) Cables might have loosened; moisture might have entered into
cables or connectors, heavy rain at present or heavy storm at
present.
Check the cable connections, LNB and other equipment
connected between the LNB and the receiver, or peak the dish.
Wait for rain/storm to subside. Ask a local satellite specialist for
advice.
b) The satellite dish is not pointing at the (correct) satellite(s).
Adjust the dish. Ask a local satellite specialist for advice.
c) Satellite dish is too small, trees or buildings in path.
Change to a larger dish or change position of dish.
d) Signal is too strong, dish is oversized.
Connect a signal attenuator to the LNB input. Ask a local satellite
specialist for advice.
Heavy rain will attenuate satellite signals, below a certain level blocking
will occur.
Make sure your dish installation is up to standards to minimize rain effects.
When in doubt, ask a local satellite specialist for advice.
Again, turn on the TV.
If the problem persists after these solutions, please contact your local
support centre or send a support mail via our website www.strong.tv.
2 x 10 W
DVB-T2: 174 MHz-230 MHz; 470 MHz-860 MHz
DVB-C: 113-858 MHz
DVB-S2: 950 MHz-2150 MHz
DTV: DVB-T2, DVB-S2, DVB-C
ATV: PAL/SECAM (BG/DK/1)
AV: PAL, NTSC, SECAM
Possible cause and solution