Table of Contents
Advertisement
Appliance door
en
Removing panels
Press the left- and right-hand sides of the cover
1.
(fig.
).
!
Remove the cover (fig.
2.
Lift out each panel (fig.
3.
carefully on a flat surface.
If necessary, you can remove the condensate trough
4.
for cleaning. To do this, open the appliance door
fully (fig.
).
$
Tilt the condensate trough up and remove it (fig.
5.
Clean the panels with glass cleaner and a soft cloth.
Wipe the condensate trough with a cloth and some hot
soapy water.
:
Warning
Risk of injury!
Scratched glass in the appliance door may develop
■
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
The hinges on the appliance door move when
Risk of injury!
■
opening and closing the door, and you may be
trapped. Keep your hands away from the hinges.
16
).
"
) and set them down
#
Fitting panels
Open the appliance door fully and refit the
1.
condensate trough. To do this, insert the trough from
above and rotate it at the bottom (fig.
Close the appliance door fully.
2.
Slide each panel back in and make sure that it is
3.
sitting correctly at the bottom in the retainer (fig.
Push each panel in at the top (fig.
4.
).
%
Put the cover back in place and press on it until you
5.
hear it click into place (fig.
Open the appliance door again fully.
6.
Close the two locking levers on the left and right
7.
(fig.
).
%
Close the appliance door.
8.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
).
!
"
).
#
).
$
).
Advertisement
Table of Contents
