Remote Access - AT&T BL102-3S Quick Start Manual

Answering system

Remote access

You can reach your answering system remotely by dialing your
home telephone number from any touch-tone telephone.
To remotely reach your answering system:
1. Dial your telephone number from any touch-tone telephone.
2. When the system answers, enter the two-digit remote access
code (19 is the default code. See page 71 to change it).
The system automatically announces the number of new or
f
old messages (if any), and then begins to play them.
3. You can also enter the following remote commands:
Remote
commands
1
2
3
33
4
5
* 5
6
* 7
8
0
4. Hang up or press 8 to end the calls.
Press to listen to all messages.
Press to listen to new messages only.
Press to delete the current message (during
playback).
Press twice to delete all old messages.
Press to repeat the current message (during
playback).
Press to stop any operation (including
recording).
Press to listen to a list of remote commands.
Press to skip to the next message (during
playback).
Press to record a new announcement.
Press to end remote access (the call will be
terminated).
Press to turn the answering system on or off.
79
Actions