KTM 450 EXC EU 2015 Setup Instructions page 7

2 SETUP
(XC‑W)
–
Connect pull switch
–
Position the speedometer and connector board. Mount and tighten screws.
Guideline
Remaining screws, chassis
102048-10
–
Position the controls on the right half of the handlebar.
C00523-10
–
Position the controls on the left half of the handlebar.
C00524-10
(all 450 EXC models, alle 500 EXC Modelle, EXC EU, EXC SIX DAYS)
–
Remove the fuel tank.
–
Position the turn signal wiring harness against the main wiring harness and
secure with cable binders.
B01749-01
–
Disconnect the plug-in connection from the main wiring harness and con-
nect the turn signal wiring harness.
–
Install the fuel tank.
B01750-01
–
Position the turn signal on each side and mount and tighten nuts.
–
Connect plug-in connection of the right turn signal using the black and
brown cable colors.
–
Connect plug-in connection of the left turn signal using the violet and
brown cable colors.
M00149-01

with the yellow and white cables.
Info
The routing of the cables can be seen in the figure.
Info
The figure shows how to route the clutch line and wiring harness.
M6 10 Nm
(7.4 lbf ft)
5