3
WORK
3.9
Installing the front fender
3.10
Removing the seat
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Activate the hand brake lever multiple times until the brake linings are in contact
with the brake disc.
M00117-11
–
Remove the motorcycle from the lift stand. (
–
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
–
Fully tighten screw
Guideline
Screw, fork stub
Main work
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
L02485-10
–
Mount and tighten screws
Guideline
Remaining screws, chassis
B01603-11
Finishing work
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Remove screw
–
Lift up the seat at the rear, pull it back and then remove it from above.
101346-10
.
.
.
p. 10)
.
M24x1.5
45 Nm
(33.2 lbf ft)
p. 8)
M8
15 Nm
(11.1 lbf ft)
.
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
p. 9)
12