Table of Contents
Advertisement
Rack-Mount and Ground the Chassis
Warning
Step 1
Attach a rack mount bracket to each side of the chassis using the six 8-32 x .375-inch Phillips screws provided in the
accessory kit.
Figure 36: Attach the Rack Mount Bracket to the Side of the Chassis
1
Chassis
3
8-32 x .375-inch Phillips screws (three per side)
Step 2
Attach the inner rails to the sides of the chassis:
a) Remove the inner rails from the slide rail assemblies.
b) Align an inner rail with one side of the chassis so that the three keyed slots in the rail align with the three pegs on the
side of the chassis.
c) Set the keyed slots over the pegs, and then slide the rail toward the front to lock it in place on the pegs. The rear key
slot has a metal clip that locks over the peg.
d) Secure the inner rail to the side of the chassis using one M3 x 6 mm screw.
e) Install the second inner rail to the opposite side of the chassis and secure with the other M3 x 6 mm screw.
Statement 1047—Overheating Prevention
To reduce the risk of fire or bodily injury, do not operate the unit in an area that exceeds the maximum
recommended ambient temperature of 104°F (40°C).
2
Rack-mount bracket
Cisco Firepower 4112, 4115, 4125, and 4145 Hardware Installation Guide
Rack-Mount the Chassis
49
Advertisement
Table of Contents
