Cisco 4112 Hardware Installation Manual page 84

Install the FIPS Opacity Shield
Figure 58: Attach the FIPS Opacity Shield to the Cable Management Brackets
1 FIPS opacity shield
3 Cable management bracket
Step 8 Attach the 15 TELs. For information on the procedure and correct placement of the TELs, see the Tamper Evidence
Label (TEL) Placement section (section 2.13 ) in the
document.
Step 9 Attach the power cable to the chassis and connect it to an electrical outlet.
Step 10
Press the power switch on the rear panel.
Step 11 Check the power LED on the front panel. See
green indicates that the chassis is powered on.
Note When you toggle the power switch from ON to OFF, it takes several seconds for the system to power
down. Do not remove the power cable until the power LED is off. After removing power from the chassis
either by moving the power switch to OFF or unplugging the power cord, wait at least 10 seconds before
turning power back ON.
Step 12
See the Cisco Firepower 4100 Getting Started Guide
Cisco Firepower 4112, 4115, 4125, and 4145 Hardware Installation Guide
80
2 8-32 x 0.375-inch Phillips screws (two per side)
FIPS 140-2 Non Proprietary Security Policy Level 2 Validation
Front Panel LEDs, on page 9
for further configuration information.
Installation, Maintenance, and Upgrade
for a description of the power LED. Solid