Table of Contents
Advertisement
Available languages
Available languages
5.13 - Total or partial deletion of memory
This procedure allows you to choose under point 05 the data that you want to delete.
5.13.1 - Procedure performed with a transmitter memorised in "Mode I"
Before starting the procedure, bring the awning (or shutter) to the midpoint of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04. Keep the t key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
05. • To cancel the entire memory: Keep the s and t keys pressed and wait for the motor to perform five movements. Upon completion, release the keys.
• To delete all memorised transmitters: do not press any key and wait until the motor performs 5 movements.
• To delete a single memorised transmitter: hold down the s key and wait for the motor to perform 3 movements. Now release the key.
button of the transmitter you wish to delete: the motor performs 5 movements.
• To delete only the limit switch heights ("0", "1", "2", "S") and intermediate heights ("H"): WARNING: – This deletion must be performed only when
you want to adjust the limit switch heights again, using a different procedure than the one used previously. Keep the n key pressed and wait for the
motor to perform 5 movements. Upon completion, release the key.
01
5
sec.
04
3
5
sec.
05
single
5
sec.
This deletion must be performed only when you want to adjust the limit switch heights again, using a different procedure than the one
used previously. Whereas, if you want to adjust heights with the same procedure, it is not necessary to delete them from memory.
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.13.2 - Procedure performed with an unmemorised transmitter
Before starting the procedure, bring the awning (or shutter) to the midpoint of its stroke.
01. Disconnect the power supply to the motor; wait 2 seconds and reconnect the power supply (you have 15 seconds to complete the next step).
02. Keep key n on an unmemorized tramsitter pressed for 8 seconds. Now release the button.
03. Disconnect the power supply to the motor; wait 2 seconds and reconnect the power supply (you have 60 seconds to complete the next step).
04. Now run the procedure in paragraph 5.13.1.
01
OFF
2
sec.
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
02
2
05
all
data
key example
3
(transmitter
to be
deleted)
02
ON
New
I – – – – – – – – – – – – – – –> max 15 sec. – – – – – – – – – – – – – –>I
3
5
sec.
5
5
sec.
(*)
"0"
5
"1"
ATTENTION!
03
OFF
8
2
sec.
sec.
03
3
5
sec.
05
all
5
sec.
05
5
5
sec.
04
ON
01
02
03
Paragraph 5.13.1
I – – – –> max 60 sec. – – – –>I
Lastly, press the
5
04
05
English – 10
Advertisement
Table of Contents
