Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for BRIO Moderna CLPOU730UVF3
Summary of Contents for BRIO Moderna CLPOU730UVF3
- Page 1 Point-of-Use Water Dispenser User’s Manual Model: CLPOU730UVF3...
-
Page 2: Table Of Contents
Table of Contents Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Intended Use . -
Page 3: Safety Information
Safety Information WARNING: To reduce risk of injury and property damage, you must read this entire guide before assembling, installing and operating the dispenser . WARNING: This product dispenses water at very high temperatures . Failure to use properly can cause personal injury . -
Page 4: Intended Use
Intended Use This appliance is intended to be used in household and similar applications such as: • Staff kitchen areas, offices, and other working environments • Farm houses • Hotels, motels and other residential type environments • Bed-and-breakfast environments • Catering and similar non-retail applications This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction... -
Page 5: Touch Panel Description
Touch Panel Description No . Description Up arrow button LED display Change filter icon Self-cleaning UV icon Down arrow button Lock button Hot water button Ambient water button Cold water button Operational Specifications Model No . CLPOU730UVF3 Rated Voltage / Frequency 115 V / 60 Hz Heating Power 600 W... -
Page 6: Technical Specifications
Technical Specifications CAUTION: This unit dispenses water at temperatures that can cause severe burns . Avoid direct contact with hot water . Keep children and pets away from unit while dispensing . Never allow children to dispense hot water without proper and direct supervision . Unplug unit to prevent unsupervised use by children . Model No . -
Page 7: Installation
Installation 1 . Determine Installation Location Place the dispenser upright . Locate the dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet . NOTICE: Do NOT plug in the power cord until the entire installation section is completed . -
Page 8: Flush The Filters
Gently tug on the tube (B) to ensure a secure connection with the feed water adapter (G) . 4 . Flush the Filters IMPORTANT: Follow this procedure every time you replace your filters . IMPORTANT: Ensure the water supply is off before you begin . Connect a filter (D) to the filter housing (C) by twisting the filter (D) clockwise . -
Page 9: Install The Filters And Complete The Installation
5 . Install the Filters and Complete the Installation After flushing, twist each filter (D-F) clockwise into the filter housings located inside the dispenser cabinet . The sediment filter goes on the left, followed by the pre-carbon filter and the post carbon filter (F) . Remove the safety plug from the water inlet hole on the back of the dispenser by pushing in the inlet hole... -
Page 10: Operation
Operation IMPORTANT: This unit has been tested and sanitized prior to packing and shipping . During transit, dust and odors can accumulate in the tank and lines . Dispense and dispose at least one quart of water prior to drinking any water . Turn the Dispenser On/Off IMPORTANT: Before you activate the hot and cold switches, ensure water has filled the tanks inside the... -
Page 11: Set The Hot Water Temperature Level
Set the Hot Water Temperature Level You can select from 3 different hot water dispensing temperature levels: H1 (hot), H2 (hotter), and H3 (hottest) . Temperature Level Dispensing Temperature Range 178°F to 184°F 184°F to 190°F 190°F to 196°F NOTE: The default temperature dispensing level for hot water is H3 (hottest) . -
Page 12: Troubleshooting
Troubleshooting Problem Solution • It takes up to one hour after setup to dispense cold water . • Make sure the power cord is properly connected to a working outlet . The cold water is not • Make sure the back of the dispenser is at least 20 cm from a wall and there is free airflow on all 20 cm sides of the dispenser . -
Page 13: Cleaning And Maintenance
Cleaning and Maintenance This dispenser runs on a continuous UV cleaning cycle . It works for 40 minutes (UV icon on the display is on), turns off for 140 minutes, and then cycles back on again as long as the dispenser is plugged in and on . -
Page 14: Filter Specifications
Filter Specifications Sediment Filter Pre Carbon Filter (Sediment, Dirt, and Rust Removal) (Chlorine, Taste, and Odor Reduction) Filter Capacity Filter Capacity 950 Gallons 950 Gallons Flow Rate Flow Rate 0 .8 GPM 0 .8 GPM Suggested PSI Suggested PSI 14 .5 - 58 psi 14 .5 - 58 psi Temperature Temperature... -
Page 15: Warranty
Warranty Brio (“Vendor”) warrants to the original purchaser of the Brio Water Coolers (the “Product”), and to no other person, that if the Product is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in the Product shall be free from defects in material and workmanship . - Page 16 ©2023 Brio Water Technology, Inc.
Need help?
Do you have a question about the Moderna CLPOU730UVF3 and is the answer not in the manual?
Questions and answers