Safety Information WARNING: To reduce risk of injury and property damage, you must read this entire guide before assembling, installing and operating the dispenser. WARNING: This product dispenses water at very high temperatures. Failure to use properly can cause personal injury.
Intended Use This appliance is intended to be used in household and similar applications such as: • Staff kitchen areas in shops, offices and other working environments Farm houses • • Clients in hotels, motels and other residential type environments •...
Indicator Panel Description Power indicator light – When illuminated, indicates that the dispenser is Hot water indicator light – When illuminated, indicates that the dispenser is heating water. Cold water indicator light – When illuminated, indicates that the dispenser is cooling water. Product Dimensions Height Width...
Installation 1 . Determine Installation Location Place the dispenser upright. Locate the dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet. NOTICE: Do NOT plug in the power cord until the entire installation section is completed.
Gently tug on the tube (B) to ensure a secure connection with the feed water adapter (E). 3 . Make the Reverse Osmosis Waste Connections The “RO” filter assembly requires a drain line connection to be installed, which removes rejected water to the sewer. The drain saddle connects the drain line from the dispenser to your drain pipe.
4 . Flush the Filters IMPORTANT: Follow this procedure every time you replace your filters. IMPORTANT: Ensure the water supply is off before you begin. Connect a filter (D) to the filter housing (C) by twisting the filter (D) clockwise. Connect the tip of the shut-off valve tube (B) to the left side of the filter housing (C).
5 . Install the Filters and Complete the Installation After flushing, twist each filter (D) clockwise into the filter housings located inside the dispenser cabinet. The sediment filter goes on the left, followed by the carbon, RO, and post carbon filter. Remove the safety plug from the water inlet hole on the back of the dispenser by pushing in the inlet hole...
Operation IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During transit, dust and odors can accumulate in the tank and lines. Dispense and dispose at least one quart of water prior to drinking any water. Turn the Dispenser On/Off IMPORTANT: Before you activate the hot and cold switches, ensure water has filled the tanks inside the...
Troubleshooting Problem Solution • It takes up to one hour after setup to dispense cold water. • Make sure the power cord is properly connected to a working outlet. The cold water is not • Make sure the back of the dispenser is at least 20 cm from a wall and there is free airflow on all 20 cm sides of the dispenser.
Cleaning and Maintenance Use the Self-Cleaning Ozone Feature It is highly recommended that you use the self-cleaning feature on a weekly basis to sanitize tanks and water lines. To activate the self-cleaning cycle, press in the self-cleaning switch (15), hold for 5 seconds, and release. The power indicator light on the front of the Self Clean dispenser will begin blinking, indicating the...
Filter Replacement Schedule Filter Type Replacement Schedule Function Performs a coarse filtration of original Sediment 6 months or 950 gallons water. Removes mud, sand, iron, rust, and suspensions, and impurities. Reduces chlorine, taste and odor, lead Pre-Carbon 6 months or 950 gallons and cysts.
Warranty Brio (“Vendor”) warrants to the original purchaser of the Brio Water Coolers (the “Product”), and to no other person, that if the Product is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in the Product shall be free from defects in material and workmanship.