Mitsubishi FR-E540-0.4K-EC Instruction Manual page 61

(3) Combined operation mode 1 (Pr. 79 "operation mode selection" = 3)
The start signal is an external signal.
The frequency setting signal is made setting using the optional
control panel or parameter unit.
Preparation
! Start signal..............Switch, relay, etc.
! Operation unit .........Control panel (FR-PA02-
! Connection cable ....Refer to (1) PU operation mode.
! FR-E5P (option)......Refer to (1) PU operation mode.
(4) Combined operation mode 2 (Pr. 79 "operation mode selection" = 4)
The start signal is entered from the operation command key
of the optional control panel.
The frequency setting signal is set using the external
frequency setting signal.
Preparation
! Frequency.................0 to 5V, 0 to 10V or 4 to 20mA DC
setting signal
! Operation unit ...........Control panel (FR-PA02-
! Connection cable ......Refer to (1) PU operation mode.
! FR-E5P (option)........Refer to (1) PU operation mode.
parameter unit (FR-PU04)
signals from an external
potentiometer or from outside the
inverter
parameter unit (FR-PU04)
47
) or
02
) or
02
3