Door Locking Gear Motor; Thermoactuators; Lock Thermoactuator; Unlock Thermoactuator - Dexter Laundry WC 00XA-12EC X Series Instruction Manual

2
Door Locking Gear Motor Assembly
1
6
9
The door locking gear motor is rotated shut with
control voltage to lock the door and releases when
10
6
voltage is removed. It is located in the left front
corner of the washer. (Original l ocking solenoid
models can be converted to the new assembly)
5
9
11
3
4
7
8

Thermoactuators

Door Lock Gear Motor
The thermoactuators are a safety device that
keeps the door from immediately unlocking if
power is lost while the machine is operating. They
are mounted under the door locking solenoid.

Lock Thermoactuator

Control voltage is applied to the lock
thermoactuator at the beginning of the cycle
making it extend and block the door locking
gear motor. This keeps the door locked for
approximately two minutes after a power failure
occurs. The lock thermoactuator does not delay
the door opening at the end of a normal cycle.

Unlock Thermoactuator

To insure that the lock thermoactuator has
retracted by the end of the cycle, one minute prior
to the end of the cycle, the unlock thermoactuator
Thermoactuators
is powered with control voltage making it extend
and unblock the door locking gear motor.

Drive Belt Removal

Turn the drive pulley while applying pressure to
the drive belt until it rolls off of the basket pulley
first and then remove from the motor pulley. Be
cautious not to drop the motor which could unhook
the tension assembly.
Reverse this procedure for installation.
Drive Belt
80
Part # 8533-081-001 7/21