Network Settings - Mitsubishi Electric MCC-50A Installation And Instruction Manual

7-2. Network settings

There are two methods to connect to the network: by using a static IP address and by using a DHCP. Refer to
section 7-2-1 when using a static IP address, and refer to section 7-2-2 when using a DHCP.
7-2-1. Using a static IP address
(1) Preparation
To use a static IP address, it is necessary to use the Network Settings window on the web browser.
Set the IP address of the computer by referring to the procedures below. The following table lists the operating
systems, browsers, and models of the computers that are supported for using the Network Settings window on the
web browser. (This setting is required only when the cloud system is connected via a wired network using a static IP
address.)
Item
CPU
Memory
Screen resolution
OS
Browser
Setting procedures for Windows
(1)
Click [Control Panel] on the Start menu, and select [Network and
Sharing Center] > [Change adapter settings] > [Local Area Connection].
Click [Properties] in the [Local Area Connection Status] window.
Note: Menu and window titles such as [Local Area Connection] and
[Local Area Connection Status] may vary with the OS versions.
(2) Select [Internet Protocol Version 4 (TCP/IPv4)], and then click
[Properties].
WT09836X01
1 GHz or faster (2 GHz or faster recommended)
2 GB or more
1024 × 768 or higher
Microsoft ® Windows ® 10
Mac OS ® X10.11
Microsoft Internet Explorer
®
Microsoft Edge Ver. 83
® ®
Google Chrome™ Ver. 73
Safari ® 12
23
Requirements
11
®