Troubleshooting - DeLonghi DINAMICA plus Instructions For Use Manual

DISPLAYED MESSAGE
REPLACE WATER FILTER
PRESS OK TO START
GENERAL ALARM: REFER TO
USER MANUAL
PLEASE WAIT
CLEANING UNDERWAY
PLEASE WAIT

18. TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact customer services.
PROBLEM
The appliance does not come on.
POSSIBLE CAUSE
The water softener filter (D6) is exhausted.
The inside of the appliance is very dirty.
The tubes inside the milk container (E) must be
cleaned.
Reminds you the filter (D6) must be replaced.
The machine must be descaled.
Energy saving is enabled.
The appliance is heating up to the optimum
temperature
The appliance has detected impurities in its
internal circuits
POSSIBLE CAUSE
It is not plugged into the mains socket. Plug into the mains socket (fig. 1).
REMEDY
Press the selector corresponding to "OK" to re-
place or remove the filter, or "ESC" to carry out
the procedure later. Follow the instructions in
section "15. Water softener filter".
Clean the inside of the appliance thoroughly,
as described in section "12. Cleaning". If the
message is still displayed after cleaning, con-
tact De'Longhi Customer Services.
Turn the froth adjustment dial (E1) to CLEAN
(fig. 18).
Replace the filter or remove it as described in
section "15. Water softener filter".
The descaling procedure described in section
"13. Descaling" needs to be performed.
To disable energy saving, proceed as described
in section "6.8 Energy saving ".
Wait for the appliance to be ready again and
reselect the required beverage. If the problem
persists, contact De'Longhi Customer Services.
REMEDY
24